Srw224g4, Front panel, Leds – Linksys BUSINESS SERIES SRW224G4 User Manual

Page 13: Back panel, Front panel leds back panel, Chapter 2, Product overview

Advertising
background image

6

Product Overview

WebView Switches

Chapter 2

CONSOLE

The Switch is equipped with a

serial port labeled Console (located on the
back of the switch) that allows you to connect
to a computer’s serial port (for configuration
purposes) using the provided serial cable. You
can use HyperTerminal to manage the Switch
using the console port.

Refer to Chapter 4: Configuration Using the
Console Interface
for more information.

NOTE:

If you need to reset the Switch, unplug

the power cord from the back of the Switch.
Wait a few seconds and then reconnect it.

SRW224G4

Front Panel

The Switch’s LEDs and ports are located on the front
panel.

Front Panel of the SRW224G4

LEDs

POWER

(Green) Lights up green to indicate

that power is being supplied to the Switch.

LINK/ACT (1-24)

(Green) Lights up green to

indicate a functional 10/100-Mbps network link
through the corresponding port (1 through 24)
with an attached device. It flashes to indicate
that the Switch is actively sending or receiving
data over that port.

LINK/ACT (G1-G4)

(Green) Lights up green to

indicate a functional 10/100-Mbps network link
through the corresponding port (G1 through
G4) with an attached device. It flashes to indicate
that the Switch is actively sending or receiving
data over that port..

1000Mbps (G1-G4)

(Amber) Lights up amber

to indicate a 1000-Mbps connection on the
corresponding port (G1 through G4) with an
attached device.

ETHERNET 1-24

The Switch is equipped with

24 auto-sensing, Ethernet network ports, which
use RJ-45 connectors. The Fast Ethernet ports
support network speeds of 10 Mbps, 100 Mbps,
or 1000 Mbps. They can operate in half and
full-duplex modes. Auto-sensing technology
enables each port to automatically detect the
speed of the device connected to it (10 Mbps,
100 Mbps, or 1000 Mbps), and adjust its speed
and duplex accordingly.

ETHERNET G1-G4

The Switch is equipped

with 4 auto-sensing Gigabit Ethernet network
ports, which use RJ-45 connectors. The Gigabit
Ethernet ports support network speeds of
10 Mbps, 100 Mbps, or 1000 Mbps. They can
operate in half and full-duplex modes. Auto-
sensing technology enables each port to
automatically detect the speed of the device
connected to it (10 Mbps, 100 Mbps, or
1000 Mbps), and adjust its speed and duplex
accordingly.

MiniGBIC (1-2)

The miniGBIC (gigabit interface

converter) port is a connection point for a
miniGBIC expansion module, so the Switch can
be uplinked via fiber to another switch. The
MiniGBIC port provides a link to a high-speed
network segment or individual workstation at
speeds of up to 1000 Mbps.

Use the Linksys MGBT1, MGBSX1, or MGBLH1
miniGBIC modules with the Switch. The
MGBSX1 and the MGBLH1 require fiber cabling
with LC connectors, while the MGBT1 requires
a Category 5e Ethernet cable with an RJ-45
connector.

SRW224G4 Shared Port Mapping

miniGBIC Port

Standard Port

miniGBIC 1

Port G3

miniGBIC 2

Port G4

Back Panel

The power port is located on the back panel of the
Switch.

Back Panel of the SRW224G4

Advertising