Linksys BUSINESS SERIES SRW224G4 - Manual (Page 35)

Chapter 5 Advanced Configuration
28 WebView Switches
VLAN Management > VLAN to Ports
The VLAN to Ports screen contains fields for configuring
VLANs to a ports.
VLAN Management > VLAN to Ports
Port Displays the interface number.
Mode Indicates the port-to-VLAN mode. The possible
field values are:
General • Indicates the port belongs to VLANs, and
each VLAN is user-defined as tagged or untagged (full
802.1Q mode).
Access • Indicates the port belongs to a single untagged
VLAN. When a port is in Access mode, the packet types
which are accepted on the port cannot be designated.
Ingress filtering cannot be enabled or disabled on an
access port.
Trunk • Indicates the port belongs to VLANs in which
all ports are tagged, except for one port that can be
untagged.
Join VLAN Defines the VLANs to which the interface is
joined.
VLAN to Ports > Join VLAN
VLANs Displays the PVID tag.
LAG Indicates if the port is a member of a LAG. If it is a
member of a LAG, it cannot be configured to a VLAN. The
LAG to which it belongs can be configured to a VLAN.
VLAN Management > GVRP
GARP VLAN Registration Protocol (GVRP) is specifically
provided for automatic distribution of VLAN membership
information among VLAN-aware bridges. GVRP allows
VLAN-aware bridges to automatically learn VLANs to
bridge ports mapping, without having to individually
configure each bridge and register VLAN membership.
VLAN Management > GVRP
The Global System LAG information displays the same
field information as the ports, but represents the LAG
GVRP information.
The GVRP screen is divided into two areas, GVRP and GVRP
Table. The field definitions for both areas are the same.
Enable GVRP Enables and disables GVRP on the device.
Interface Displays the interface on which GVRP is
enabled. The possible field values are:
Port • Indicates the port number on which GVRP is
enabled.
LAG • Indicates the LAG number on which GVRP is
enabled.
GVRP State Check this checkbox to enable GVRP on the
interface.
Dynamic VLAN Creation Check this checkbox to enable
Dynamic VLAN creation on the interface.
GVRP Registration Check this checkbox to enable VLAN
registration through GVRP on the device.
The Update button adds the configured GVRP setting to
the table at the bottom of the screen.