Liebherr HC1001 - Manual (Page 11)

u Slightly loosen the
screws Fig. 20 (51) .
u Secure the bottom mount-
ing bracket Fig. 20 (50) to
the unit wall with a ø4x19
chipboard screw
Fig. 20 (29) .
u Break off the protruding
end of the cover
Fig. 20 (53) .
u Tighten the screws
Fig. 20 (51) .
u Place the cover Fig. 20 (54)
into position on the bottom
mounting bracket
Fig. 20 (50) .
Fig. 20
u Slide the equalizer trim Fig. 11 (20) toward the handle side
as far as it will go.
u Close the appliance door.
6.2 Fitting the unit doors
Fig. 21
The fitting aids Fig. 21 (30) are required for both doors.
You must therefore fit the unit doors one after the oth-
er.
u Verify the 5/16 '' (8 mm) presetting. (Distance between
appliance door and lower edge of crosspiece)
u Raise the fitting aids Fig. 21 (30) to the unit door height.
Bottom stop edge ▲ of fitting aid = top edge of unit door
to be fitted.
u Unscrew the cross-
piece Fig. 22 (31) by
undoing the lock-
nuts Fig. 22 (32) .
u Hang the cross-
piece Fig. 22 (31) on
the inside of the unit
door using the fitting
aids Fig. 22 (30) .
Fig. 22
For a 23-5/8 '' (600 mm) wide recess:
u To center the crosspiece Fig. 22 (31) : Mark a short center
line on the unit door and place the tip of the arrow on the
crosspiece over it.
w Distances to the outer edges are the same to the right
and to the left.
For a 24 '' (609.6 mm) wide recess:
u To align the crosspiece Fig. 22 (31) : Mark a short center
line on the unit door and place the tip of the arrow on the
crosspiece over it. Now shift the crosspiece
Fig. 22 (31) 3/16 in. (5.5 mm) towards the hinge side.
For chipboard doors:
u Fasten the crosspiece Fig. 22 (31) with at least 6 screws
Fig. 22 (41) .
For frame and panel doors:
u Fasten the crosspiece Fig. 22 (31) with 4 screws
Fig. 22 (41) at the edge.
u Lift up the fitting aids Fig. 22 (30) , turn them around, and
insert them into the adjacent openings.
Fig. 23
u Attach the unit door on the adjusting bolts Fig. 23 (33) and
loosely screw the locknuts Fig. 23 (32) onto the adjusting
bolts.
u Close the door.
u Check the gap between the door and the surrounding unit
doors.
u To laterally align the unit door: Move the unit door in the X
direction.
u To align the unit door in height and in lateral inclination:
Adjust the adjusting bolts Fig. 23 (33) with a screwdriver.
w The unit door is flush and in alignment with the surround-
ing unit fronts.
u Tighten the locknuts Fig. 23 (32) .
Ensure that both metal
edges are flush, sym-
bol //:
u Drill pilot holes in the
door of the unit (you
could make a prelimi-
nary hole with a bra-
dawl).
Fig. 24
u Fasten the appliance door to the unit door with screws
Fig. 24 (41) through the mounting brackets Fig. 24 (34) .
Fig. 25
Installation
11