Lexmark 258x - Manual (Page 34)

Page/Form Layout
2-14
Draft document
Set Automatic Perforation Skip
This command specifies the number of lines to be skipped at the bottom of each page,
which creates a bottom margin.
USAGE NOTES
•
This command remains in effect until:
– Cancel Skip Perforation (ESC O) printer command is received.
– Set Form Length in Lines (ESC C) printer command is received.
– Set Form Length in Inches (ESC C 0) printer command is received.
•
Valid values for n are 1 through 255 (decimal), 01 through FF (hexadecimal).
Cancel Automatic Perforation Skip
This command cancels Set Automatic Perforation Skip (ESC N).
Proportional Space Mode
This command turns proportional space mode on and off.
USAGE NOTES
•
The value of n can be either of the following:
– 1 (dec) 01 (hex) = ON
– 0 (dec) 00 (hex) = OFF
•
(259x only) ON changes character pitch to the LQ proportional mode. OFF
returns character pitch in LQ mode to the pitch selected before the
proportional space mode was turned on.
Format ESC N n
Decimal 27 78 n
Hexadecimal 1B 4E n
Format ESC O
Decimal 27 79
Hexadecimal 1B 4F
Format ESC P n
Decimal 27 80 n
Hexadecimal 1B 50 n