Lennox Hearth COUNTRY COLLECTION 506033-34 - Manual (Page 4)

4
WOODSTOVES WITh LEG BASE
Step . Using a 9/16” wrench or socket loosen the left heat shield bolt.
This bolt is located on the bottom side of the leg heatshield as
shown. See Figure 14.
Figure 14
Step 2. Insert snap switch bracket between the heatshield and the bottom
of firebox making sure entire assembly is on the left side of the
heatshield bolt. Slide back until the notch on the bottom front of
the bracket falls into the lip on the front of the heatshield, and as-
sembly is parallel with side of firebox. See Figures 15 and 16.
Step 3. Locate the tabs on the back of the control box. Slide the tabs onto
the upper edge of the left side of the heatshield. See Figures
17 and 18.
Figure 15
Figure 17
Left heat Shield Bolt
Figure 16
Snap Switch Bracket
heat Shield
Snap Switch Bracket
Upper Edge Of The
Left Side heatshield
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step . Visually inspect wires are clear of contact with bottom of firebox.
See Figures 11 through 13.
Step 2. Plug the power cord into a grounded 120 VAC receptacle. Do
not route the power cord under the stove or allow it to come in
contact with any surface of the stove.
Figure 13
Snap Switch harness