Lexmark 280 - Manual (Page 85)

1 Open the front door, and then open the top cover.
CAUTION—HOT SURFACE: The fuser and the inside of the printer near the fuser may be hot. Wait for the
fuser to cool before clearing jams from this area.
2 Grasp the paper on each side and pull it forward.
3 Close the top cover, and then close the front door.
4 Press .
Paper jam behind the fuser unit
Warning—Potential Damage: To avoid overexposing the photoconductors, do not leave the front door open longer
than 10 minutes.
1 Open the front door, and then open the top cover.
CAUTION—HOT SURFACE: The fuser and the inside of the printer near the fuser may be hot. Wait for the
fuser to cool before clearing jams from this area.
2 If the paper is jammed behind the fuser, then you will need to remove the fuser unit.
Warning—Potential Damage: Do not touch the center of the fuser unit. Doing so may cause your fingers to
touch the roller underneath the fuser unit. Touching the fuser roller will damage the fuser.
a Turn the screws on the fuser unit to the left to loosen them.
b Lift the handholds on each side of the fuser unit, and then pull forward to remove it.
c Place the fuser unit on a flat surface.
Clearing jams
85