Replacing a toner cartridge – Lexmark 280 User Manual
Page 165
If you see Ready on the printer display screen after you have replaced a photoconductor, follow Steps 1 through 7
below.
1
To specify the replaced photoconductor, press .
Supplies Menu appears.
2
Press .
Replace Supply appears.
3
Press .
4
Press the down arrow button until All, Cyan photoconductor, Magenta photoconductor,
Yellow photoconductor, or Black photoconductor appears, depending on the photoconductor
you just replaced.
5
Press .
<color> photoconductor replaced appears.
Yes appears.
6
Press .
7
Press until Ready appears.
The task is complete.
Replacing a toner cartridge
When 88 Replace <color> cartridge, 88 <color> cartridge nearly low, or 88 <color>
cartridge low appears on the printer control panel, or when print becomes faded, try to extend the life of the
specified cartridge.
1
Open the front door.
Warning—Potential Damage: Make sure the printer is not open for 10 minutes or more to avoid overexposing
the photoconductor units to light.
Maintaining the printer
165