LG CodePlus MUX/MOD Feature Card HCS6320 - Manual (Page 22)

22 206-4183
(Continued from previous page)
3. Click on the Submit button when you are ready to continue.
The system will display an overview of the settings and then prompt you to reset the
HCS6320, for example:
DHCP mode selected
Reset the Controller card to activate new IP settings.
or
Static IP mode selected
IP address:
xxx.xxx.xxx.xxx
Subnet mask: xxx.xxx.xxx.xxx
Default gateway: xxx.xxx.xxx.xxx
Reset the Controller card to activate new IP settings.
4. If you are ready to reset the HCS6320 immediately, click on the Reset button located below
the results text.
Note: If you intend to modify additional configuration settings during the current session,
you may wait until all changes are complete before you reset the HCS6320 (see “Perform
an External Card Reset” on page 23 for further information); however, note that IP settings
will not take effect until the HCS6320 resets.
Change the (Reload Pro:Idiom Key) Password
This option enables you to change the password required to reload the Pro:Idiom key on
selected transcoders. The default password is “service”.
1. With the Controller Menu on display, click on the
Change button at the right of the Change
(Reload P:I Key) Password field.
The system will initiate a series of password prompts in pop-up windows.
2. At the Enter the Current Password prompt, type the current password and click OK.
3. At the Enter New Password prompt, type the new password and click OK.
4. At the Confirm New Password prompt, retype the new password and click OK.
When the password is successfully changed, the system will display confirmation, for example:
Password changed.
Configuration Options via GUI (Cont.)