Configuration options via command line (cont.) – LG CodePlus MUX/MOD Feature Card HCS6320 User Manual
Page 42
42
206-4183
Access the Satellite Receiver Menu for the Selected Transcoder
See “Satellite Receiver Menu Commands” on pages 43 to 47 for detailed information on
satellite STB configuration options.
Update Firmware on the Selected Transcoder
This command updates the firmware on the selected transcoder card. To update firmware on
all transcoders or on the HCS6320, see “Update HCS6320 and/or Transcoder Firmware” on
page 35.
Caution: Do NOT initiate simultaneous menu sessions while a firmware update is
in progress. Doing so will interfere with the active processes and may corrupt the
system configuration and/or cause the HCS6320 card to cease normal operation.
If you are not sure of the current firmware version, view and record the transcoder hardware
ID (firmware version) before you initiate the firmware update. See “View Hardware
Information
for the Selected Transcoder
” on page 40.
1. Confirm the directory location of the required firmware update configuration (.cfg) and
package (.pkg) files. Note: For a TFTP file transfer, the firmware update files must be
available on the same machine as the TFTP server.
2. At the
[HCS7720 (#)] Command >
prompt, type
upd and press Enter.
3. At the
Use TFTP to transfer files (y/n)?
prompt, either:
• Type
y and press Enter to use TFTP for the firmware update.
• Type
n and press Enter if you will not use TFTP for the firmware update. At the next
system prompt:
Use XMODEM to transfer files (y/n)?
, type
y and press Enter.
4. Complete the update using the selected transfer mode (Xmodem or TFTP). Refer to
“Update HCS6320 and/or Transcoder Firmware” on page 35 for further information.
5. Reset the transcoder card (see “Reset the Selected Transcoder Card” below).
Reset the Selected Transcoder Card
At the
[HCS7720 (#)] Command >
prompt, type
irst and press Enter to initiate the reset.
After reset, the transcoder card resumes normal operation.
Return to the HCS6320 Main Menu
At the
[HCS7720 (#)] Command >
prompt, type
ret and press Enter to return to the
HCS6320 Main Menu.
Configuration Options via Command Line (Cont.)