Lennox Hearth Shoreline 33/40 DV INS - Manual (Page 15)

15
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
2. Separate the glowing embers (F) into quarter size pieces and place
along ports on burner pan. DO NOT cover burner secondary holes
on burner pan. The pattern for the glowing embers should be similar
to what is shown in Figure 22.
3. Place center log (B) on supports towards bottom left and top right of
log (B). See Figure 23.
4. Place left log (C) on pin in back. Push log against left side of refractory
in front. See Figure 24.
C
B
F
pin
5. Locate groove in center log (B), and place the top of the right log
(D) in groove with the bottom end of the log resting against the right
refractory panel. See Figure 25.
6. Place the front log (E) as shown in Figure 26, making sure no burner
ports are covered. Place the decorative lava rock around logs as
desired, again making sure there are no ports or holes covered.
E
D
Groove for log (D)
7. Figure 26 shows the complete set of ceramic logs in the correct loca-
tions.
Figure 24
Figure 23
Figure 22
Figure 25
Figure 26
Glowing Embers
Bag of Glowing
Embers (rockwool)
Separate into Quarter
Size (separate) Pieces