Troubleshooting & repair, Inverter board resistance test (continued) – Lincoln Electric V155-S User Manual

Page 49

Advertising
background image

INVERTER BOARD

D9

Collector

Channel B

D7

D3

Output

Terminals

Point 2

Point 1

(center leg)

R24 = PTC

(solder pad)

Collector

Channel A

Red

Black

FIGURE F.7 – INVERTER BOARD TEST POINTS

INVERTER BOARD RESISTANCE TEST (CONTINUED)

7. Check the diodes D3 and D9 for “shorts” or “opens”.

See Figure F.7.

8. Check diode D7, but remember, some resistance

(approx. 27-28 ohms) will be read in both polarities.

This will occur because D7 is a snubber diode and is

connected in parallel to the snubber resistors R8, R9

and R10. See wiring diagram X0519. See Figure

F.7.

9. Check the five output diodes for “shorts” or “opens”.

Check from the center terminal (Point 1) of each

Diode (all center terminals of the diodes are com-

mon with the heatsink) to the large copperl area

“point 2”. See Figure F.7.

Note: Actual voltage readings will vary depending on

the meter being used. Similar tests on all devices

should give similar results

10. Check the resistance between the thermal protec-

tion terminals R24. It should be about 36-40 ohms.

See Figure F.7.

11. Check the resistance between output terminal con-

nections. It should be about 8.5Kohms.

TROUBLESHOOTING & REPAIR

F-17

F-17

INVERTEC® V155-S

Retur

n

to

Section

TOC

Retur

n

to

Section

TOC

Retur

n

to

Section

TOC

Retur

n

to

Section

TOC

Retur

n

to

Master

TOC

Retur

n

to

Master

TOC

Retur

n

to

Master

TOC

Retur

n

to

Master

TOC

Advertising