LG STB1000 - Manual (Page 6)

6 206-4147
Setup Checklist
Installation and Setup
__ Unpack the STB1000 and all accessories.
Accessories
provided:
• 6 ft AC power cord
• 5 ft RS-232C-F to RS-232C-F null-modem cable with 3.5 mm stereo plug
• 5 ft RS-232C-M to RS-232C-F straight-through cable
• 5 ft HDMI to DVI-M cable
• 1 ft DVI-F to HDMI adapter cable
• 5 ft Audio cable with 3.5 mm stereo plugs
• IR receiver with attached 3.5 mm stereo plug cable (3 ft), plus mounting bracket
• 5 wall mount brackets with 5 screws for attaching the STB1000 to a wall
• Installer Remote with batteries
__ Determine the installation location for the STB1000, display panel stand, or mount.
__ Determine mounting and installation requirements, for example, AC power source outlet, antenna/cable
service connectors, any external equipment required for system operation, all necessary cables,
wires, and connectors, and any other additional required hardware, etc.
__ Install batteries in the remote control.
__ Install the display panel on VESA mount or stand, as necessary, following the manufacturer’s
instructions.
Note: It may be advisable to make all cable connections before installing on VESA mount or stand.
Hardware Connections
__ Install any additional hardware as appropriate to your institution, LAN, etc.
STB1000 Cable Connections
__ Make all connections to the rear and jack panel connectors.
__ Connect the STB1000 to a standard 120V 60 Hz AC power source.
Commercial Mode Setup
__ Complete Commercial Mode Setup (configure all relevant Installer Menu items as required of your
institution and configure display features for the end user).
Software Installation
__ Install or configure any software as applicable, for example, PPV, etc.