LG STB1000 - Manual (Page 9)

9 206-4147
POWER ST
A TUS
STB1000
DIGITAL VIDEO OUT
AC IN AC OUT
MAX 8A 960W
USB SERVICE ONL Y
AV IN 2
VIDEO L/MONO -AUDIO - R
AUDIO OUT
INT PILLOW
PILLOW SPEAKER ANT
DISPLAY IR IN
IR RECEIVER IN AC 120V~ 60H z
STB1000
Vent Holes
Ventilation
The STB1000 generates heat during operation and needs to be provided with
adequate ventilation to assure continued reliable operation. See recommenda-
tions below.
Proper clearance for air to fl ow around the STB1000 must be
provided.
Note: While accommodating STB1000 ventilation requirements, also be
sure proper ventilation is provided for the display panel. Refer to display panel
installation documentation for ventilation requirements and specifi cations.
Note: In addition to the ventilation requirements indicated below, be sure to allow
enough clearance (4 to 5 inches) for wiring clusters attached to the STB1000.
1. Ventilation holes on the top and bottom of the STB1000 are provided for
ventilation cooling (see fi gures at right).
2. The vent holes should never be blocked or obstructed to airfl ow but have an
unimpeded path through any enclosure back to room temperature air.
3. The unit and its venting, should not be installed near heat sources, such as
radiators or heating ducts.
4. If the unit is placed in an enclosure, tests should be run to confi rm that the
ambient temperature around the unit under normal expected operating condi-
tions is stable and does not exceed 40 degrees Celsius (104° F). The ambient
temperature can be determined by placing a thermometer near the air intake
vents in the proposed enclosure and measuring the temperature every hour,
under normal operating conditions, until two successive readings repeat.
If the temperature does not stabilize but keeps increasing above 40 degrees
Celsius (104° F), ventilation is inadequate and needs to be improved.
5. Always provide adequate air space between the ventilation areas and adja-
cent structures.
Ventilation / Mounting the STB1000
STB1000
Vent Holes
POWER ST
A TUS
STB1000
Vertical Installation (Wall Mount) Using Supplied Angled
L-Brackets
Angled brackets are provided so that the STB1000 can be mounted on a fl at
vertical surface, like a wall. Install the angled brackets with the screws provided.
Then, mount the STB1000 on the wall using appropriate screws.
Note: The brackets are designed to be mounted to typical 16-inch spaced wall
studs. Do not mount the STB1000 on a weak wall surface. If wall studs are
not available, use another appropriate fastening system.
Monitor/STB1000 Wall Mounting System
The display panel and STB1000 can be mounted to a wall using an optional
monitor/interface STB wall mounting system. For further information on the
mounting system, contact your LG dealer.