Logic Soundlab VS-20 - Manual

1
VS-20 Control Surface Plug-in for Logic and GarageBand
About This Plug-in
VS-20 Control Surface Plug-in for Logic and GarageBand is plug-in software that lets you use the Cakewalk V-Studio 20 (which will be referred to simply
as “the VS-20” from here on) with Apple’s Logic or GarageBand music production software.
Once you install this software on your Mac, you’ll be able to use the VS-20 as a convenient controller for Logic or GarageBand.
Operating Requirements
• Operating system: Mac OS X 10.5 Leopard or later
• Software version: Logic Pro/Express 8 or later, GarageBand ‘09 or later
Installation
NOTE
You must install the VS-20 driver before you install the VS-20 Control Surface Plug-in.
1. Quit Logic Pro/Express or GarageBand if it is running.
2. Double-click [VS20ControlSurfacePlugin.pkg] and install it as directed by the messages in the screen.
MEMO
After installation, you might see the following control surface setup dialog box when you start up Logic Pro/Express; simply close the dialog box.