Panasonic DMP-B500 - Manual (Page 11)

G
et
ti
n
g
st
ar
te
d
VQT2J81
(ENG)
11
∫ Detaching the battery pack
When not using for long periods of time
≥ Detach the battery pack (> above).
(Even when the unit is turned off, there is a small amount of
voltage running through the unit, and this may result in a
malfunction.)
≥ Recharge the battery for re-use.
∫ Recharging the battery pack
Attach the battery pack and connect the AC
adaptor (> 10).
≥ The [CHARGE] indicator lights while charging the battery,
and the [CHARGE] indicator turns off when battery charging
is finished.
∫ Approximate recharging and play times
(Hours)
≥ Play time indicated above may differ depending on the use.
≥ To change the LCD brightness (> 12, “Adjusting the pictures
on the LCD screen”).
∫ Checking the remaining battery charge
Not displayed when the AC adaptor is in use.
Press [SUB MENU] while the power is “On”
Remaining charge is displayed for a few seconds at the bottom
right of the screen.
Charge the battery pack when the display starts to flash.
≥ Appears automatically when there is only a few minutes of
charge remaining.
Turning on/off the unit
Press [POWER Í] (approx. 0.5 sec.).
The unit is turned off when [POWER Í] is pressed again.
≥ When the “Auto Power Off” is set to “On” (initially set to “On”),
the unit will be turned off automatically after 15 minutes
(5 minutes when the battery pack is used) when it is in
stopped status (> 40).
≥ The startup will take time. The operation related to startup of
the unit after turning on this unit can be quickened by setting
the initial setup “Quick Start” (> 40) to “On”. (The power
consumption will increase)
≥ You may hear operational sounds when the unit is turned on,
but this is due to the initialization of the pickup unit, and it is
not a malfunction.
After installation of the unit and pressing [POWER Í] for the
1st time, a screen for the basic settings will appear.
Follow the on-screen instructions and make
the settings with [3, 4] and [OK].
“On-screen Language” (> 38), “Picture Quality Mode” (> 12),
“DST” (> 40), “Clock Adjustment” (> 40) and “Quick Start”
(> 40) are set.
≥ After completing “Easy Setting”, you can continuously
perform “Network Easy Setting” (> 32).
≥ You can perform this setup anytime by selecting “Easy
Setting” in the Setup menu. (> 40)
≥ You can also change this setting individually.
The unit is turned off automatically after set time has passed.
Switch by pressing the [OFF TIMER].
It will switch every time it is pressed.
Battery pack Recharging *1
*1 When the unit is off [at 20 oC (68 oF)]
Play *2
*2 At room temperature using headphones [at 20 oC (68 oF)]
LCD brightness level
j5 0 i5
DY-DB30
(included/
optional)
5 3.5 3 2.75
DY-DB15
(optional)
4 2.75 2.5 2.25
DY-DB100
(optional)
7.5 5.5 5 4.5
RELEASE
DETACH ATTACH
Bottom side of this unit
2 Slide.
1 Press and hold.
[CHARGE] indicator
(Orange light)
Recharge
(flashing) Fully charged
Easy Setting
Turn the unit off automatically
Off Timer 0 : 30
e.g., 30 min.
Off 1:00 0:30 2:00 3:00 6:00 12:00
VQT2J81~Body1_eng.fm 11 ページ ２０１０年３月１７日 水曜日 午後４時４分