Panasonic DMP-B500 - Manual (Page 33)

Ne
two
rk
VQT2J81
(ENG)
33
Access Point Connection Setting
Network Easy Setting (Connection Check)
Network Easy Setting (Internet Connection Check)
≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting “Network
Easy Setting” in the Setup menu. ( > 32)
≥ You can redo these settings individually using “Network
Settings”. ( > 39)
≥ After performing network settings on this unit, the settings
(encryption level, etc.) of the Wireless router (Access point)
might change. When you have trouble getting online on your
PC, perform the network settings on your PC in accordance
with the settings of Wireless router (Access point).
When you experience problems
with settings
Display Check the following
A conflict with another
device occurred. ≥ Please wait a few moments,
and then try again.
A time out error occurred.
≥ Setting of the Wireless router
(Access point) for MAC
Address etc.
≥ The SSID and the encryption
key of the Wireless router
(Access point).
≥ Please wait a few moments,
and then try again.
An authentication error or a
time out error occurred.
A device error occurred.
≥ Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, contact our
Customer Service Center.
OK
Access Point Connection Setting
Failed to connect to the access point.
A conflict with another device occurred.
Do you want to configure Access Point Connection
Setting again ?
Yes No Display
Check the
following
1. LAN cable connection or
Connection to access point
: Fail
≥ Connection and
settings of
Wireless router
(Access point)
≥ Connection of
the LAN cables
(
> 31)
2. IP address setting : Fail
3. Connection to gateway : Fail
1. LAN cable connection or
Connection to access point
: Pass
≥ Connection and
settings of
Wireless router
(Access point)
≥ Connection and
settings of the
hub and router
≥ Settings of “IP
Address/DNS
Settings” (
> 39)
2. IP address setting : Fail
3. Connection to gateway : Fail
1. LAN cable connection or
Connection to access point
: Pass
2. IP address setting : Pass
3. Connection to gateway : Fail
Display Check the following
Cannot find the server.
(Error code: B019)
≥ “Primary DNS” and “Secondary
DNS” settings of “IP Address/DNS
Settings” (
> 39)
Failed to connect to
the server.
(Error code: B020)
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of “Proxy Server Settings”
( > 39) and the router
OK
Network Easy Setting (Connection Check)
Yes No
Complete.
1. LAN cable connection
2. IP address setting
3. Connection to gateway
LAN cable is not connected.
Please check the connection.
Select “Yes” and press [OK] to check network
connection again. Select “No” and press [OK]
to finish Network Easy Setting.
: Fail
: Fail
: Fail
OK
Network Easy Setting (Internet Connection Check)
Complete.
- Connection to the Internet : Fail(Error code: B019)
Failed the connection test.
Cannot find the server.(Error code: B019)
Please refer to the operating instructions for the cause
of the error and the solution for it.
Press [OK].
DMPB500PP-VQT2J81_eng.book 33 ページ ２０１０年３月１６日 火曜日 午後４時８分