Indicators and screen messages, Indicators screen messages – Panasonic DMP-B500 User Manual

Page 44

Advertising
background image

VQT2J81

(ENG)

44

Indicators and screen
messages

The [CHARGE] indicator flashes rapidly.

¾ There is a problem with the battery pack. Turn the unit on and

check the message on the LCD. (

> below, 45)

¾ Update of the firmware did not complete successfully.

Perform the update again. (

> 34)

The [CHARGE] indicator flashes slowly.

¾ Battery pack charge is low. The unit will turn off automatically

after a few minutes.

SD card access indicator is flashing

¾ This unit is reading from the SD card, or writing to the SD

card. Do not remove the SD card from this unit.

Cannot read. Please check the disc.

¾ Clean the disc. (> 5)
¾ You inserted a disc that has not been finalized. (> 6)

ERROR

U580

¾ A problem has occurred with the battery pack. Consult your

dealer.

ERROR

U581

¾ The battery pack has been recharging but has failed to

recharge for some reason. Recharge again.

ERROR

U582

¾ You are recharging in a location that is too hot or too cold.

Recharge at normal temperature [

i5 to i35 oC (i41 to

i95 oF)].

U72
U73

¾ There was a problem when connecting the HDMI.

jConnected device is not compatible with HDMI.
jUse a cable with an HDMI logo.
jThe HDMI cable is damaged.

U76

¾ BD-RE, BD-R, BD-Video or DVD Video with copyright

protection cannot be played back since the device connected
to the HDMI terminal is not compatible with the copyright
protection.

U77

¾ Video cannot be output since the copyright protection

information on the BD-RE, BD-R, BD-Video or DVD Video
being played back is not valid.

F

∑∑

H

∑∑

(

∑∑ stands for a number.)

¾ A problem has occurred. (Numbers following the “F” or the

“H” will be different depending on the status of the unit) Turn
off the unit once, and turn it back on. Alternatively, turn off the
unit, disconnect the AC adaptor and the battery pack, and
attach them back again.

Authorization Error.
This unit is not authorized to play this title.

¾ [DivX]: You are trying to play the DivX VOD content that was

purchased with a different registration code. You cannot play
the content on this unit. (

> 24)

Cannot play.

¾ You inserted an incompatible disc (Discs recorded in PAL

video, etc.). (

> 6)

Cannot display on this unit.

¾ You tried to play a non-compatible image. (> 42)
¾ Re-insert the SD card.

No disc is inserted.

¾ The disc may be upside down.

Rental Expired.

¾ [DivX]: The DivX VOD content has zero remaining plays. You

cannot play it. (

> 24)

$ This operation is not available.

¾ Some operations are unsupported by the unit. For example;

j[BD-V]: During playback, reverse slow-motion or reverse

frame-by-frame is not possible.

$ This operation is prohibited by this disc.

¾ Depending on the disc, you may not be able to perform

search or skip when film previews and warning screens are
being played back.

Cannot connect.
Please check the connection of the LAN cable.

¾ When a hub is used but its Link lamp does not light up, check

the cable connection, LAN terminal connection, cable itself (a
crossover cable may have been used by mistake), etc.
(

> 31)

IP address is not set.

¾ The “IP Address” in “IP Address / DNS Settings” is “---. ---. ---

. ---”. Set the “IP Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address acquisition if
necessary.) (

> 39)

Indicators

Screen messages

DMPB500PP-VQT2J81_eng.book 44 ページ 2010年3月16日 火曜日 午後4時8分

Advertising