Planet Technology DVR-471 - Manual (Page 25)

4/16-ch H.264 Digital Video Recorder
4. BASIC OPERATION and SETUP
4.1 Basic Operation
4.1.1 Power On/Off
After connecting power adaptor and other devices (HDDS) with this DVR, turn the power on.
a.
The video signal system (NTSC or PAL) is automatically detected.
b. Power Failure Recovery
This DVR automatically reverts back to programmed record parameters upon
power restoration.
If there is no video signal, the video signal system is set to NTSC. Do not input the PAL type video signal or it
may cause the DVR’s malfunction. In this case, turn off and on again.
4.1.2 Screen Display
a. Multi display
To change a single camera display to the multi camera, press the MULTI button.
b. Full screen display
Press the desired camera number button to display on the monitor.
NOTE:
-Use the +10 Button when you select two digit camera numbers.
EX) Camera Number 12 = Press the +10 Button, and then press the No. 2 Button.
-CAMERA/NUMBER INPUT buttons are used to input the password in the password lock function as well.