Polaroid PTV-701 User Manual

User guide, Getting started scanning for channels, 0” lcd display

Advertising
background image

DC

Car Charger

AC

Adaptor

A / V

Cables

12

13
14

16

15

18

17

19

20

3

1

2

4 5 6 7 8 9 10 11

User Guide

In the box

Digital TV

Remote

Control

Antenna

Location of controls

Included

Installing the batteries

Polaroid and Polaroid & Pixel are trademarks of PLR IP Holdings, LLC, used under license. PLR

IP Holdings, LLC does not manufacture this product or provide any Manufacturer’s Warranty or

support.

www.polaroid.com

9

10

11
12
13
14
15
16
17
18
19
20
21

23

22

1

2

3

4

5

6

7

8

1. Open the battery cover.

2. Place the 2 (AAA) batteries (included) into the

compartment. Be sure the positive and negative

terminals are positioned correctly as shown.

3. Close the battery cover.

2 - (AAA)

Batteries

User Guide

Remote control

Connecting the antenna

1. With the antenna in the down position, screw it into the RF IN antenna jack

on the TV.

2. For the best reception, stretch the antenna out to its fullest length before

scanning for channels.

Charging

This television contains a built-in rechargeable battery. You may power the

television by charging its internal battery or you may power the television by

using the included AC adaptor. Follow the instructions below to charge the

television properly.

1. Connect the AC adaptor to the DC 9-12V IN jack on the TV and plug it into a

wall receptacle.

2. Charging time depends on whether the TV is ON during charging or in

standby mode.

If the TV is ON – the charge time is approximately 6 hours.

If the TV is in standby mode – the charge time is approx

imately 4 hours.

3. When battery strength is low, the TV will display the following icon on the

screen: ,this means it is time to recharge the battery.

4. The [Standby/Power] indicator light on the front of the TV turns green when:

The power cord is connected, and the TV is fully charged.

The TV is running on battery power.

The first time the television is turned on you must scan for available channels.

You should also scan for available channels whenever you are in a new area, or

when reception is bad.

1. Make sure that the antenna is connected to the TV and slide the power

[ON/OFF] switch to the ON position.

2. When you turn on the TV for the

first time, the following screen

will be displayed:

3. If this screen does not appear, then press the [AUTO/OK] button on the TV.

4. Press the [VOL+] button to select “Yes” and press [AUTO/OK] button

to confirm.

5. The TV will start scanning

for available channels and

store them into memory.

Scanning by remote control

1. Press the [MENU] button on

the remote and press the [ ]

button to select:

2. Press the [ ] button to select

“Antenna”.

3. Press the [ ] button to select

“Air” or CATV (cable TV),

depending on the type of

connection.

4. Press the [ ] button to scroll to

“Auto Scan” and press the [ ]

button twice. The TV will start

scanning for available channels

and store them into memory.

Note: Do not move or unplug the TV while scanning for

channels/subchannels.

2

1

Getting started

Scanning for channels

Note: The antenna must be connected to receive

the highest amount of channels available during

channel scanning.

Note: Use the included car charger to charge the TV in a car

or boat.

This television is not meant to be used in a

moving vehicle. ATSC Digital tuners are not

capable of receiving a signal when in motion.

Do not move or unplug the TV while scanning

for channels/programs as this will interrupt the

scanning process and you will not receive all

possible channels/subchannels.

Select

1.
2.
3.
4.
5.
6.
7.
8.

9.

10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.

LCD screen
Dual speakers
[Standby/Power] indicator
[MENU] button
[CH-] button
[CH+] button
[AUTO/OK] button
[VOL-] button
[VOL+] button
[MODE] button
Remote sensor
RF IN antenna jack
VIDEO IN jack
AUDIO IN L jack
AUDIO IN R jack
Headphone jack
Power [ON/OFF] switch
DC 9-12V IN jack
TV stand (pull)
Battery compartment

1.
2.

3.
4.
5.
6.
7.

8.

9.

10.

11.

12.
13.

14.
15.
16.
17.
18.
19.
20.
21.
22.
23.

[MUTE] button
[PICTURE] button
[MENU] button
[SLEEP] button
[ ] left button
Numeric buttons
[ ] previous channel
button
[VOL-] volume down
button
[POWER] button
[MTS] sound field
button
[ZOOM] display
mode button
[EXIT] button
[EPG] program
guide button
[ ] up button
[ ] right button
[ENTER] button
[ ] down button
[TV/AV] source button
[INFO] program information button
[CH+] channel up button
[CH-] channel down button
[ ---- ] channel program button
[VOL+] volume up button

PTV-701

Portable Digital Television

Portable Digital Television

7.0” LCD Display

Cover

Remote control

Batteries

Advertising