Pelonis FS40-G5 User Manual
Pelonis, Owner’s manual
PELONIS
OWNER’S MANUAL
1
1
6
6
”
”
O
O
s
s
c
c
i
i
l
l
l
l
a
a
t
t
i
i
n
n
g
g
S
S
t
t
a
a
n
n
d
d
F
F
a
a
n
n
w
w
i
i
t
t
h
h
R
R
e
e
m
m
o
o
t
t
e
e
C
C
o
o
n
n
t
t
r
r
o
o
l
l
Model No. FS40-G5
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
RULES FOR SAFE OPERATION
1. Never insert fingers or any other objects through the grill when the fan is running.
2. Disconnect the fan when moving it from one location to another.
3. Disconnect the fan when removing the grills for cleaning.
4. Be sure the fan is on a stable surface when operating to avoid overturning.
5. DO NOT use the fan in a window as rain may create an electrical hazard.
OVERHEAT PROTECTION
The fan motor is equipped with a thermal fuse that turns the fan off in case of
overheating. If overheating occurs, please send the fan in for repair (refer to the
Service & Support section of this manual).
WARNING
1. To reduce the risk of fire or electric shock, do not use this fan with any solid-
state speed control device.
2. This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
3. Do not leave the fan running unattended.
4. Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-
Consult the dealer or an experienced radio TV technician for help.
U L
®