Panasonic KX-TG5932AL - Manual (Page 40)

Answering System
40
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume operation, enter a remote
command within 15 seconds, or the
voice guidance starts.
Turning on the answering system
remotely
If the answering system is off, you can turn
it on remotely.
1
Dial your phone number.
2
Let the phone ring 15 times.
L
The unit answers your call with the
greeting message.
L
You can hang up, or if you call from a
touch tone phone, you can enter your
remote code and begin remote
operation (page 39).
Skipping the greeting message to leave
a message
You can leave a message just as any
outside caller can. Call your phone
number. When the answering system
picks up, press {*} to skip the greeting
message and record your message after
the beep.
Answering system
settings
Remote code
A remote code must be entered when
operating the answering system remotely.
This code prevents unauthorised parties
from listening to your messages remotely.
The default setting is “11”.
1
{ MENU} i {0}{6}{3}
2
Enter the desired 2-digit remote code.
i
{Save} i {OFF}
Ring count
You can change the number of times the
phone rings before the unit answers calls.
The default setting is “4”.
“Toll saver”: The unit answers on the
2nd ring when new messages have been
recorded, and on the 4th ring when there
are no new messages. If you call your
phone from outside to listen to new
messages (page 39), you will know that
there are no new messages when the
phone rings for the 3rd time. You can then
hang up without being charged for the call.
1
{
MENU} i {0}{6}{1}
2
Select the desired setting. i {Save}
i
{OFF}
For Service Provider Voice Mail
Subscribers
To receive Voice Mail and use answering
system properly, please note the following:
{*}{
4} Erase currently playing
message
{*}{ 5} Erase all messages
Key Remote command
TG593xAL.book Page 40 Tuesday, April 11, 2006 10:31 AM