Philips DP 6000 - Manual (Page 3)

3 FCP PROGRAMMING
3.1 PS 6000 menu selection
To enter the PS 6000 menu, OPEN THE DESK EDITOR, SELECT and PRESS key “A”as shown in para. 2.3 and observe the correct
display indication.
DISPLAY
“PS menu”
When the PS 6000 menu is opened, the following sub menus can be selected to program the FCP.
KEYSTROKE SUB MENU
C Communications/Initialisation
DIRECT CALL KEY Direct Call info
MONITOR KEY Call FCP setting
A Auto scan info.
ALARM KEY Relay settings
E FCP memory edit (USED ONLY FOR “SERVICE”)
3.2 Entering The Program Variables
As long as the PS menu is open, the text “PS menu” will be displayed and a bleep will sound every second. When a PS 6000 sub menu is
selected, the bleep will stop and the desk display will show the text associated with the sub menu selected.
When a sub menu has more than one step, the next step to be programmed can be selected by pressing the PROGRAM key.
At the end of some sub menus the display will show “update?”. To enter the programmed data into the memory, press the PROGRAM key
again. By pressing the RESET key, instead of the PROGRAM key, the new entered data is lost. The desk will revert to PS menu selection.
The following text describes the menus and commands to be programmed into the FCP:
4 MENU KEY “C” Communication/initialisation
COMMAND “0” - FCP DEFAULT SETTING (see TABLE 1) DISPLAY SHOWS “ DEF FCP NR”
Key in the address of the FCP (if more than one FCPs are connected) to be set to default values (01 - 31). Only connected FCPs may be
selected.
The memory of the FCP will be initialised
The FCP will restart its program by a soft reset
The address allocated in the desk will be deleted
The top row of LEDs of the FCP will start to blink
If when powered up, the top row of LEDs are blinking, the FCP is in the default mode (see TABLE 1 .)
Remark: only one FCP initialised.
COMMAND “1” - FORCE SOFT RESET DISPLAY SHOWS “SFTRES (1/0)”
Keystroke “1” - Will reset ALL FCPs and restart the program execution as from power-up
Keystroke “0” - NO restart execution
COMMAND “2” - SHOW /STOP ADDRESS (all FCPs) DISPLAY SHOWS “SHWADR (1/0)”
Keystroke “1” - All FCPs will show their addresses by illuminating the appropriate LED
Keystroke “0” - Stops Show Address Mode and returns FCP to current status
After either keystoke the desk will return to the “Comm Service” menu
NOTE: “Stop Show Address” mode must always be selected after “Show Addres” mode to restart communication.
INSTALLATION INSTRUCTION 69 DP 6000 DIGITAL PAGING SYSTEM
Page 3/15 December 1997