Planet Technology PL-501v2-US - Manual (Page 17)

a b
Network AB
c
The procedure is as follows:
1. Press the security button on the adapter (a) or (b) during 1~3 seconds.
2. Press the security button on the adapter (c) during 1~3 seconds.
3. The PWR LED starts to flash.
4. After a few seconds, the PWR and HP LEDs should be on. The configuration
is successful.
Reset Button
This section describes how to use Reset button, this button can be used to clear
ALL data and restore ALL settings to the factory default values.
The procedure is as follows:
1. Hold the reset Button down while Power On for a few seconds.
2. Release the reset button.
3. All the LEDs will off, and then start again.
4. PL-501v2 is now using the factory default values.
17