Planet Technology PL-103E - Manual (Page 13)

9
3. Powerline Ethernet Bridge Installation
3.1 Hardware Installation
1. Plug one end of an UTP category 5 cable into the computer, switch or hub ’s LAN
port.
2. Plug the other end of the network cable into the 10/100 RJ-45 Ethernet ports on
PL-103E.
3. Plug the PL-103E to the power outlet.
NOTE: Because PL-103E sends data over the powerline of your house, it is best
to plug it directly into a power outlet. Do not plug PL-103E into a UPS power strip
with surge protection. PL-103E has its own power filter for protection against
surges.
4. Perform procedure 1~3 for all other PL-103E on your network.
3.2 Driver Installation
PL-103E does not need any driver to work if connected to a PC, since the PC should
install an Ethernet Adapter and its driver already.