Psiber Data Systems Pinger Plus Network IP Tester - Manual

UPDATE PINGER SCREEN
The Pinger Plus firmware can be updated over the network as
new revisions are released. Notice of a new revision will be provided
on the Psiber web site (www.psiber.com). Download the new firmware
file, connect the Pinger Plus to the network, go to the Update Pinger
Setup screen, press the Select function key and the unit will Link to the
network and enable the firmware update mode. Next run the down-
loaded file on the computer. The program will ask for the current IP
address of the Pinger Plus (see Pinger IP Address Setup screen) and
your password. When the update is complete the program will notify the
user and the Pinger Plus immediately goes to the Link screen and
searches for the Link. WARNING: Any disruption while programming is
in process will result in the unit being unuseable and will have to be
returned to the factory for repair. Install a fresh set of batteries or connect
the AC adapter to the unit before starting an update.
POWER
Duration
- The Pinger Plus will typically provide about 5 to 6 hours of
operation from a set of four AA alkaline batteries. An AC adapter is also
provided which will power the unit but does not recharge the batteries.
Auto Power Down
- The Pinger will automatically turn off after the time
selected in the Power Down Setup screen or will run continuously until
manually turned off when “ON” is selected for Power Down.
Low Battery - When the batteries are below the level required for the
Pinger Plus to operate properly, a battery graphic appears in the upper
right hand corner of the display.
WARRANTY
Psiber Data Systems Inc. warrants that the product shall be free from defects in parts or workmanship for
a period of 12 months from the date of purchase if used in accordance with Psiber Data Systems Inc. operating
specifications.
THIS IS THE ONLY WARRANTY MADE BY Psiber Data Systems Inc. AND IS EXPRESSLY MADE
IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
Should any parts or workmanship prove defective, Psiber Data Systems Inc. will repair or replace at Psiber
Data Systems’ option, at no cost to the Buyer except for shipping costs from the Buyer’s location to Psiber Data
Systems Inc. This is Buyer’s SOLE AND EXCLUSIVE REMEDY under this Agreement.
This warranty does not
apply to products which have been subject to neglect, accident or improper use, or to units which have been altered
or repaired by other than an authorized repair facility.
Return of Equipment - To return a product to Psiber Data Systems Inc., first obtain a Return Authorization
number from our Customer Service by calling 619-287-9970. The RA# must be clearly marked on the shipping label,
or the package will not be accepted by Psiber Data Systems Inc. See sample label below.
To: Psiber Data Sytems Inc.
7075-K Mission Gorge Road
San Diego, CA 92120
RA# XXXXXXXX
Pinger, Plus + , psiber and the Psiber logo are trademarks of Psiber Data Systems Inc.
Copyright 2003 Psiber Data Systems Inc. All rights reserved.
P P P P P
INGER INGER INGER INGER INGER
P P P P P
LUS LUS LUS LUS LUS TM
NETWORK IP TESTER NETWORK IP TESTER NETWORK IP TESTER NETWORK IP TESTER NETWORK IP TESTER
USER’S GUIDE USER’S GUIDE USER’S GUIDE USER’S GUIDE USER’S GUIDE
+ ++ ++