Paradyne Hotwire ATM Line Cards 8385 - Manual (Page 37)

3. Configuration
8335-A2-GB20-70 February 2003 3-15
4. Save the changes as prompted.
Copy Model 8355 DSL Port Configurations
Procedure
To copy DSL Port Configuration screen information for the Model 8355 to/from
another port:
1. Select an Action:
Copy – To copy the configuration of one port to another port.
2. Enter the name of the source port to be copied (dsl1 through dsl24) in the
Copy From field.
3. Enter the name of the destination port for the configuration information (dsl1
through dsl24) in the Copy To field.
4. Enter yes at the Save Changes? prompt to copy.
Loss of Power Seconds
Trap Threshold
ATU-R A number from 0 to 900, or a D for Disable
(Default = Disable).
If the number of Loss of Power Seconds (LOP) events
equals or exceeds the selected number within a 15-minute
period, an SNMP trap is sent. If set to Disable or 0, no LOP
trap is ever sent. If set to 1, a trap is sent after each LOP
event.
Rate Increase
ATU-C/ATU-R 0 to 2176 kbps in 32 kbps increments, or a D for
Disable (Default = Disable).
If the current rate is greater than or equal to the previous
rate, plus this threshold, an SNMP trap is sent. If set to
Disable, traps are disabled for the event.
Rate Decrease
ATU-C/ATU-R 0 to 2176 kbps in 32 kbps increments, or a D for Disable
(Default = Disable).
If the current rate is less than or equal to the previous rate,
minus this threshold, an SNMP trap is sent. If set to 0, traps
are disabled for the event.
Link Up/Down Trap Enable or Disable to enable/disable link up/down traps
(Default = Enable).
Enable – Enables link up/down traps.
Disable – Disables link up/down traps.
Initialization Failure
Trap
ATU-C Enable or Disable to enable/disable InitFailure traps as
specified in RFC 2662 (Default = Disable).
Enable – Enables InitFailure traps.
Disable – Disables InitFailure traps.
For . . . Enter . . .