Paradyne Hotwire ATM Line Cards 8385 - Manual (Page 65)

3. Configuration
8335-A2-GB20-70 February 2003 3-43
Procedure
To configure SN management:
1. Select the Index number (1–10) of the management channel(s) you wish to
modify, or 0 to add a new management channel.
To scroll to the previous or next group of management channels, type u (for
Up) or d (for Down) in the Index field.
2. Position the cursor in the field you wish to modify. Type the value you want
and press Enter.
3. Press Ctrl-z and save the changes as prompted.
For . . . Enter . . .
Interface Select the interface to be configured (dsl1:1 through
dsl16:1 on the Model 8335 or dsl1:1 through dsl24:1 on
the Model 8385).
IP Address The IP address that the DSL provider will use to manage the
SN. Duplicate endpoint/management IP addresses are not
allowed. This field is normally specified through the NMS
interface, although you can also specify it here. If you clear
this field, the route to the SN and the ATM connection are
deleted.
Subnet Mask The IP subnet mask that the DSL provider will use to
manage the SN. This field is normally specified through the
NMS interface, although you can also specify it here.
VPI The VPI of the connection, from 0 to 15 (Default = 0).
The default of 0 should be used in most cases since all
certified SNs are configured to use the factory default.
VCI The VCI of the connection, from 32 to 255 (Default = 33).
The default of 33 should be used in most cases since all
certified SNs are configured to use the factory default.