Pioneer DRM-600 User Manual

Pioneer Hardware

Advertising
background image

Attaching Pioneer CD-ROM Drives to Computers Running Windows95

August 1995

Windows95 operating system contains built in drivers for Pioneer's DRM-624X, DRM-604X, DRM-
602x and DRM-600 CD-ROM drives. These drivers also support the Pioneer DR-U124X. Users can
connect the Pioneer CD-ROM drives following the instructions below, Power ON the computer with
Windows95 loaded and separate icons with assigned drive letters will be visable in My Computer
window for each CD-ROM tray available.

Installing a Pioneer CD-ROM Drive

Note: If a Pioneer CD-ROM Drive has been connected to your system under DOS or Windows 3.x
remove old Pioneer Drivers from the system before installing Windows95.

The follow these steps to use your Pioneer CD-ROM drive in Windows95:

1.

If you are newly installing a SCSI controller card, Windows95 should automatically detect the
card on boot up. See the Windows95 User's Manual for information about installing new
cards. Also, refer to Troubleshooting, point #1 in this document.

2.

After you have confirmed that the SCSI controller card is properly installed, power down the
Pioneer CD-ROM drive and the computer system. Securely attach the SCSI cable between
the drive and the SCSI controller in the computer.

3.

If the Pioneer drive is the last devicve in the SCSI chain, make sure it is terminated.

DRM-624X Termination ON = DIP SW 2 UP
DRM-604X Termination ON = Set separate Termination Switch ON
DRM-602X Termination ON = DIP SW 2 UP
DR-U124X Termination ON = DIP SW 5 (from right to left) not Jumpered

Note: All units can be easily terminated by using an External Terminator Block and turning
the internal termination switch OFF.

If the Pioneer Drive is in the middle of the SCSI Chain, make sure termination is OFF. The
last device on the SCSI chain and the SCSI controller card must be terminated. If you also
have an internal SCSI device connected to the controller, disable termination on the
controller.

4.

Verify that each SCSI device is set to a unique SCSI ID address.

5.

Power ON the Pioneer CD-ROM drive.

6.

Power ON the computer running Windows95.

7.

On boot-up you will see the floppy drives, hard drives and CD-ROM drive icons appear under
the "My Computer" window. One icon will appear for each CD-ROM disc installed in the
Pioneer CD-ROM drive.

Advertising