Pioneer SUPERTUNERIIID+ AVH-P7850DVD - Manual (Page 24)

3 Touch ESC to return to the display of
each source.
Operating the menu by using the
joystick
You can also perform most of the menu items
by using the joystick.
! Switch the remote control operation mode
to AVH to operate the menu by using the
joystick on the remote control. (Refer to
page 19.)
1 Click the joystick during display of each
source to display AUDIO MENU.
AUDIO MENU appears on the display.
2 Move the joystick left or right to dis-
play the function names you want to oper-
ate.
3 Move the joystick to select the desired
function.
4 Press BAND/ESC to return to the display
of each source.
# You can return to the previous display by
pressing
BACK.
Opening and closing the
LCD panel
The LCD panel will be opened or closed auto-
matically with the turning of the ignition
switch on or off. You can turn off the automatic
close/open function. (Refer to page 96.)
! The automatic close/open function will op-
erate the display as follows.
— When the ignition switch is turned OFF
while the LCD panel is opened, the LCD
panel will close after six seconds.
— When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will be opened automatically.
— Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to the next page.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press
OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
CAUTION
Keep hands and fingers clear of the unit when
opening, closing, or adjusting the LCD panel. Be
especially cautious of children
’s hands and fin-
gers.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
! If you can hear the LCD panel knocking
against your vehicle
’s console or dashboard,
touch TILT ( ) to move the LCD panel a little
forward.
! When adjusting the LCD panel angle, be sure
to touch TILT ( / ). Forcibly adjusting the
LCD panel by hand may damage it.
% Touch TILT ( / ) to adjust the LCD
panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you touch
TILT ( / ) and hold.
Basic Operations
En
24
Section
04