Attaching the control panel stand covers – Panasonic EP30004 User Manual

Page 13

Advertising
background image

12

3

Attaching the control panel stand to the right or left side panel of the unit

(Diagram shows attachment to right armrest.)

The position of the control panel when seated can be
selected by choosing the appropriate hole for the screw.

Near

Approx.
20˚

Far

4

Attaching the control panel stand covers

(On both the right and left sides)
The method for attaching the covers is the same for both sides.
The diagram shows the side where the control panel stand is
attached.

1. Insert the top tabs on the cover into the bottom

notches on the armrest.

2. Insert the bottom tabs into the notches on the

armrest.

1. Insert the attachment screw into the lower hole first

and then tighten lightly by hand.

2. Securing the stand with the attachment screws.

Tighten the two screws for the remaining two holes
lightly by hand and then tighten firmly with the allen key.

2

Control panel stand

1 Insert the attachment

screw in either hole and
then tighten.

Attachment screw

Allen key

Use this screw
Attachment Screw (M6 Ч 16)

Ч 3

(Silver × 3)

Cover for Side WITH
Control Panel Stand

Cover for Side WITHOUT

Control Panel Stand

Notches

Top tabs

Control panel
stand cover

Notches

Bottom tabs

Push the cover until
you hear it click.

Control panel
stand

Allen key

Allen key

Control panel stand

Attachment

screw

Attachment screw

Hole

Hole

To attach the control panel stand using the attachment
screws, tighten the screws level with the holes as
shown in the figure below.
If the screws are tightened at an angle, the hole may
become deformed and the screws may become stuck in
the middle.

Tighten the screws
level with the holes.

Do not tighten the
screw at an angle
with the hole.

EP30004.indb 12

2007/07/19 13:07:38

Advertising