Panasonic EP30004 - Manual (Page 20)

19
1. Body scanning will commence when the program is selected.
The body scanning will properly detect height ranges between approximately 4'7" and 6'8" (140 and 185 cm).
1
2
3
4
Sit as far back in the seat as
possible with your head on the
pillow.
Correct Massage
Position
Adjust the pillow
height so that the
bottom edge of the
pillow is at ear level.
See page 37.
The unit will automatically
recline to the correct
measuring position.
Raised
approx. 55˚
Reclined
approx. 12˚
1 NECK (Neck)
2 SHOULDER (Shoulder)
3 MIDDLE (Back)
4 LOWER (Lower back)
2. Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder
position, and a soft tapping action begins to determine your shoulder height.
Massage Head
Tapping
action
Keep your head on the pillow until the soft tapping begins.
Lifting your head from the pillow will result in incorrect
determination of the shoulder position.
3. Confirm that the shoulder position has been correctly determined according to the position of the soft tapping.
Too low
Too high
Correct position of the massage head
(The point where the tapping action should be felt.)
When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for
approximately 15 seconds), and use the POSITION button to move the massage heads up or down.
A single press of the button will raise or lower
the massage heads approximately 0.5" (1.2 cm).
4. The massage will start after body scanning is complete.
The legrest height will adjust automatically based on the body scanning results. The soles of the feet should be touching
the footrest wells. You may still adjust the length of the legrest with the lever on the right side of the seat (see next page).
You may also further adjust the height of the ottoman electronically (see page 34).
•
EP30004.indb 19 2007/07/19 13:07:42