Panasonic TQBJ0350 - Manual (Page 73)

ENGLISH -
73
Settings
SECURITY menu
See z “Navigating through the menu”
( Æ page 40).
See z “MAIN MENU” and “SUB MENU”
( Æ page 41).
When you apply to the [SECURITY] menu z
before you change the password to your original,
perform to input the following factory default
password operation.
Press ▲►▼◄▲►▼◄ and <ENTER> button.
Attention
When you apply to the SECURITY menu after you z
change the password to your original in the [SECURITY
PASSWORD CHANGE] menu, input the original
password operation.
Note
Only asterisks * will appear on the screen to represent z
the actual characters of the password when the password
is entered.
SECURITY PASSWORD
The [SECURITY PASSWORD] screen can be
displayed when the power has been turned on. If the
correct password is not entered, operations other
than using <STANDBY ( )> button and <AV MUTE>
button will not be possible.
Press ▲▼ to select [SECURITY 1 )
PASSWORD].
Press ◄► to switch [SECURITY
2 )
PASSWORD].
The setting will change as follows each time z
◄► is pressed.
OFF ON
OFF Deactive
ON Active
Note
[PASSWORD] is set to [OFF] by default and when z
initialized.
Change the SECURITY PASSWORD regularly and make z
it uneasy to guess.
The security password becomes valid when setting of z
the security password is turned [ON] and then the MAIN
POWER switch is turned off.
SECURITY PASSWORD
CHANGE
The password can be changed.
Press ▲▼ to select [SECURITY 1 )
PASSWORD CHANGE].
Press <ENTER> button.
2 )
The [SECURITY PASSWORD CHANGE] z
screen will be displayed.
Press ▲▼◄► and numeral keys to 3 )
set the password.
Up to 8 buttons can be set as the password. z
Press <ENTER> button. 4 )
For the purposes of confirmation, 5 )
enter the password again.
Press <ENTER> button.
6 )
Note
Only asterisks * will appear on the screen to represent z
the actual characters of the password when the password
is entered.
If the password input second does not match with the z
password input first, an error message is displayed. In
this case, input the correct password again.
When numerals are used in the SECURITY PASSWORD, z
initialization of the security password will be necessary if
the remote control is lost. For the method of initialization,
consult your dealer.