Pioneer PDP-507XD - Manual (Page 64)

64
En
Enjoying through External Equipment 12
Connecting control cords
Connect control cords between the Plasma Television and
other PIONEER equipment having the
t logo. You can then
operate the connected equipment by sending commands from
its remote control unit to the remote control sensor on the
Plasma Television.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Television when operating the connected equipment.
NOTE
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.
About SR+
The CONTROL OUT terminal on the rear of the Plasma
Television supports
SR+ that allows linked operations with a
PIONEER AV receiver. SR+ presents functions such as the
input switch linkage operation function and the DSP surround
mode display function. For more information, see the
instruction manual that came with the PIONEER AV receiver
supporting
SR+.
NOTE
• While in connection through SR+, the volume on this system
is temporarily minimized.
• When making control cord connections, use the SR+ cable.
• When making control cord connections with one or more
pieces of Pioneer equipment, directly connect the Plasma
Television and the Pioneer amplifier that supports
SR+. Do
not connect other equipment between them.
Controlling other equipment using the
supplied remote control unit
Using the supplied remote control unit, you can control other
equipment in connection: a set-top box (STB), DVD player,
DVD/HDD recorder (DVR), or VCR.
Before using this function, you need to preset the supplied
remote control unit with the manufacture code of the
equipment to be controlled. When you then want to control the
equipment, press
SELECT on the remote control unit to select
an appropriate mode depending on the equipment; the
selection is switched among TV, STB, DVD/DVR, and VCR. The
corresponding mode indicators on the remote control unit
show the currently selected mode.
Presetting manufacture codes
1
Press SELECT on the remote control unit to select the STB,
DVD/DVR, or VCR mode depending on the equipment.
2
After confirming that the indicator of the previously
selected mode goes off, press and hold
SELECT, and then
press 1 on the remote control unit.
• The corresponding mode indicator flashes.
3
Press 0 to 9 to enter a 3-digit manufacture code.
• See the manufacture code list on page 65 to identify an
appropriate code.
• The mode indicator lights up for approximately one
second and then goes off; presetting the manufacture
code is completed.
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
Plasma Television (rear view)
When SR+ is not used:
The control cables (commercially
available) are mono sound cables
with mini plugs (no resistance).
When
SR+ is used:
Use the SR+ cable (available as
option).
TV/DTV
SELECT
TV STB
DVD/
DVR VCR
SOURCE
P
1 2 3
4 5 6
7 8 9
PC 0
INFO
INPUT 5
TV/DTV
SELECT
TV STB
DVD/
DVR VCR
SOURCE
P