Initial settings, Controller 85, Displaying the initial set- tings menu – Pioneer CNDV-40R User Manual

Page 87: Switching the warning tone, Switching the auxiliary setting, Setting the rear output and sub- woofer controller

Advertising
background image

85

Chapter 5

Combining and Using Pioneer AV Equipment

Initial Settings

Initial settings lets you perform initial set up of
different settings for Pioneer AV Head Unit (AVH-
P6400CD or AVH-P6400).

Displaying the INITIAL SET-
TINGS MENU

1

Press the SOURCE button and hold until
the source is off.

2

Press the A.MENU (AUDIO) button and
the OFF SOURCE MENU is displayed.

3

Press

5 or to select “INITIAL SET-

TINGS”, and press the A.MENU (AUDIO)
button.
The INITIAL SETTINGS MENU is displayed as
follows:
DETACH WARNING
AUX (AUXILIARY)
REAR SPEAKER
TEL/GUIDE MUTE/ATT

You can operate a desired function. For
details, refer to the pages for each of the func-
tions.
Use the following instructions to operate each
particular setting.

❒ To cancel initial settings, press the BAND/

ESC button.

Switching the warning tone

If the operation panel of the AV Head Unit is not
detached from the AV Head Unit within five sec-
onds of turning off the ignition, a warning tone
will sound. You can turn off this warning tone.

1

Press

5 or to select “DETACH WARN-

ING” from the INITIAL SETTINGS
MENU, and press the A.MENU (AUDIO)
button.

2

Select the warning tone on or off with

5

or

.

Pressing

5 or ∞ will switch WARNING

between “ON” and “OFF”.

Switching the auxiliary setting

It is possible to use auxiliary equipment with Pio-
neer AV Head Unit (AVH-P6400CD or AVH-
P6400). Activate the auxiliary setting when using
auxiliary equipment connected to Pioneer AV
Head Unit (AVH-P6400CD or AVH-P6400).

➲ AUX ➞ Page 80

1

Press

5 or to select “AUX (AUXIL-

IARY)” from the INITIAL SETTINGS
MENU, and press the A.MENU (AUDIO)
button.

2

Select the auxiliary setting on or off with
5 or .
Pressing

5 or ∞ will switch “AUX” between

ON” and “OFF”.

Setting the rear output and sub-
woofer controller

Pioneer AV Head Unit’s (AVH-P6400CD or AVH-
P6400) rear output (rear speaker leads output
and RCA rear output) can be used for full-range
speaker (“REAR SPEAKER:FULL”) or sub-
woofer (“REAR SPEAKER:SUBWOOFER”)
connection. If you switch rear output setting to
the “REAR SPEAKER:SUBWOOFER”, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.

Initially, the Pioneer AV Head Unit (AVH-
P6400CD or AVH-P6400) is set for rear fullrange
speaker connection (“REAR SPEAKER:FULL”).

When full range speakers are connected to rear
output (when “REAR SPEAKER:FULL” is
selected), you can connect the RCA subwoofer
output to a subwoofer. In this case, you can
select whether to use the subwoofer controller’s
(low pass filter, phase) built-in “S.W. CON-

Advertising