Panasonic WV-BP332 - Manual (Page 15)

-13-
The following adjustment should be made by qualified
service personnel or system installers.
1. Loosen the screws on the flange-back adjusting
ring.
2. Turn the flange-back adjusting ring to the desired
position.
Caution: When the C-mount lens is mounted, do
not rotate the ring counterclockwise by force
after it stops. If the ring is rotated by force, the
inner lens or CCD image sensor may be dam-
aged.
3. Tighten the screws on the flange-back adjusting
ring.
Note: If the camera is connected to the Quad
System, glare may appear at the edge of the
camera picture on the monitor.
If this bothers you, adjust the lens focus to
reduce the glare.
Focus adjustment for
C-mount lens
Focus adjustment for
CS-mount lens
Screws
Flange-back
Adjusting Ring
FOCUS OR FLANGE-BACK ADJUSTMENT