Panasonic KX-TG6432 - Manual (Page 45)

Useful Information
45 For assistance, please visit http://www.panasonic.com/help
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General use
Programmable settings
Problem Cause/solution
The unit does not work. L Make sure the batteries are installed correctly
(page 9).
L Fully charge the batteries (page 9).
L Check the connections (page 9).
L Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L The handset has not been registered to the base
unit. Register the handset (page 27).
I cannot hear a dial tone. L The base unit’s AC adaptor or telephone line cord
is not connected. Check the connections.
L If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the wall
jack directly. If the unit operates properly, check
the splitter.
L Disconnect the base unit from the telephone line
and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to have the
unit repaired. If the working telephone does not
operate properly, contact your service provider/
telephone company.
The indicator on the
handset flashes slowly. L New messages have been recorded. Listen to the
new messages (page 33).
L New voice mail messages have been recorded.
Listen to the new voice mail messages (page 38).
Problem Cause/solution
I have changed the display
language to a language I
cannot read. L Change the display language (page 13).
While programming, the
handset starts to ring. L A call is being received. Answer the call and start
again after hanging up.
TG643x(e).book Page 45 Monday, December 1, 2008 10:13 AM