Paradox Hellas S.A. Digiplex EVO EVO192 - Manual (Page 21)

EVO Systems 19
9.0 Trouble Display
9.1 Trouble Display
If your system experiences any problems, Trouble(s) [TRBL] to View will appear on the
screen, or the
T RBL action light will illuminate. The Trouble Display will only display the
troubles that occur in the area(s) to which the keypad has been assigned. Potential
troubles have been sorted into eight groups. Only the troubles which are relevant to you
are listed and described below. If a trouble that is not described or listed below appears,
contact your installer. To view the Trouble Display:
1. Press the [ TRBL ] button.
The Group Heading with the trouble will appear on the screen. Press the [ S] and [T]
buttons to scroll between the Groups experiencing a trouble.
On the DGP2-648BL LED keypad, The T RBL
action light will flash and the numerical
light(s) representing group heading number(s) will illuminate.
2. Press the [ NUMBER ] of the Trouble you wish to view.
We strongly suggest that if any troubles occur, contact your installer
immediately to have your system serviced.
9.1.1 Group 1: System
[1] AC Failure
The control panel has detected a power failure. This means that your system is
running on the backup battery. If this trouble occurs when your establishment is
not experiencing a power failure, call your installer for repairs.
[2] Battery Trouble
The backup battery is disconnected, needs to be recharged, or replaced.
[5] Bell Absent
The system has detected that the bell or siren is not connected.
9.1.2 Group 2: Communicator
[1] TLM1
The control panel is unable to access the main telephone line.
[2] to [5] Fail to Communicate (1 to 4)
The control panel tried all assigned telephone numbers and failed to contact the
monitoring station.
[6] Fail to Communicate PC
The control panel is unable to communicate with the WinLoad software.
9.1.3 Group 5: Zone Tamper
The zone(s) that was tampered with will be displayed on the LCD screen.
9.1.4 Group 6: Zone Low Battery
If a wireless device's battery needs to be replaced, the zone that is assigned to
the device will be displayed on the LCD screen.
9.1.5 Group 7: Zone Fault
A wireless device is no longer communicating with its receiver, or a connection or
CleanMe
TM
trouble is occurring with your smoke detectors.
LCD LED
LCD
LED