Feature demo mode, Adjusting the response positions of the, Touch panels (touch panel calibration) – Pioneer AVH-P4200DVD User Manual

Page 9: Before you start

Advertising
background image

The microprocessor must be reset in the fol-
lowing situations:
! Before using this unit for the first time after

installation

! If the unit fails to operate properly

! When strange or incorrect messages ap-

pear on the display

1

Turn the ignition switch OFF.

2

Press RESET with a pen tip or other

pointed instrument.

RESET button

(AVH-P4200DVD)

RESET button

(AVH-P3200DVD/AVH-
P3200BT)

Note

Switch your engine ON or set the ignition switch
to ACC ON before pressing

RESET in the follow-

ing situations:
! After completing connections
! When erasing all stored settings
! When resetting the unit to its initial (factory)

settings

Feature demo mode

The feature demo automatically starts when
you select

Off for the source and continues

while the ignition switch is set to ACC or ON.

To cancel the feature demo, press and hold
MUTE. Press and hold MUTE again to restart.
Operating the feature demo while the car en-
gine is turned off it may drain the battery
power.

Important

Failure to connect the red lead (ACC) of this unit
to a terminal coupled with ignition switch on/off
operations may lead to battery drain.

Adjusting the response
positions of the touch panels
(Touch Panel Calibration)

If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel. Refer to Adjusting
the response positions of the touch panels
(Touch Panel Calibration) on page 70.

En

9

Section

02

Before

Y

ou

Start

Before You Start

Advertising