Panasonic BL-C160 User Manual
Important information, Network camera, How to use the documentation
Important Information
Network Camera
Model No.
BL-C140
BL-C160
© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
PQQX16440ZA KK0408CM0
How to Use the Documentation
This manual is written for both the BL-C140 and BL-C160. Available
features and operations vary slightly depending on the model. You can
confirm the model no. of your camera by checking the model no. printed on
the front of the camera.
Model number suffixes “A” is omitted from the following model numbers
shown in this document, unless necessary. BL-C140A, BL-C160A
All documentation can be found on the included CD-ROM.
• Important Information (PDF format; printed version also included)
This document. Provides general information and safety instructions for
using the camera.
• Installation Guide (PDF format; printed version also included)
Describes how to physically connect the camera to the power supply
and network, as well how to mount or place the camera for regular use.
• Setup Guide (PDF format; printed version also included)
Describes how to set up the camera so that it can be accessed using a
PC.
• Operating Instructions (HTML format)
Explains how to operate, program, and maintain the camera.
• Troubleshooting Guide (HTML format)
Provides solutions for problems you may have when using the camera.
Abbreviations
• The Network Camera is referred to as “the camera” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
IMPORTANT SAFETY INSTRUCTIONS
When using this unit, basic safety precautions should always be followed
to reduce the risk of fire, electric shock, or personal injury.
1.
Read and understand all instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Attach the Safety Wire to the camera to prevent it from dropping.
6.
After taking away the sand or the dust on the lens cover, wipe the lens
cover with a dry cloth.
7.
Do not block any ventilation openings. Install in accordance with
instructions.
8.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
9.
Protect the AC adaptor cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where
they exit from the unit.
10. The AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
11. Only use attachments/accessories such as stand specified by the
manufacturer.
12. Do not touch the unit, the LAN cable, AC adaptor, or AC adaptor cord
during lightning storms.
13. Unplug the unit when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as when the AC
adaptor is damaged, the unit does not operate normally, or after the
unit has been dropped.
15. Prolonged exposure to direct sunlight or halogen light may damage
the image sensor.
16. Keep the sensor-range caps out of reach of children to prevent
swallowing.
17. Unplug this unit from power outlets if it emits smoke, an abnormal
smell or makes unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
18. The camera features a splash-resistant body, but it is not waterproof.
19. The AC adaptor, the AC adaptor cord, and the power transfer unit are
not splash resistant, and are intended for indoor use only.
20. When connecting the cable, waterproof the cable using the included
right-angle joint, foam strip and self bonding tape.
21. When installing cables through the ground, do not connect cables
under the ground. Install cables through a conduit to protect them from
water.
22. For BL-C160: LED radiation
CAUTION:
The camera of this unit utilizes LED lights.
Do not look directly at the LED lights for long periods of time, as this can
cause weakened eyesight.
SAVE THESE INSTRUCTIONS
FCC and Other Information
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Environment:
Do not install the camera where the temperature is less than -20 °C (-4 °F)
or greater than +50 °C (+122 °F). Allow 10 cm (4 inches) clearance around
the unit for proper ventilation. Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive
powder.
When you leave the unit unused for a long period of time, disconnect the
AC adaptor from the outlet.
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this device.
CR Coin Cell Lithium Battery Information:
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See
CLASS 1 LED PRODUCT
LED properties
LED output: Max 0.72 mW/Max 0.73 mW
Wavelength: 455 nm/555 nm
Emission duration: Continuous
No responsibility will be taken by our company with respect to
consequences resulting from the use, damage or both of the
camera.
Please read this document before using the product, and save this document for future
reference.
Panasonic Network Camera Website:
Outdoor Ready