Panasonic TX-76PW300A - Manual (Page 33)

33
Connecting Equipment to the TV
Rear Panel Connections
When using a VCR with the television always connect the Aerial to the VCR and connect an RF Cable (not
supplied) between the VCR RF-Out and the television RF-In.
You can watch videos by either tuning the television to the VCR
(see page 27) or by connecting the VCR to the rear AV terminals.
Note: When connecting a mono VCR through the RF-In, please switch the TV to mono.
Connecting a DVD player or Set-top Box to the AV Input
The audio and video inputs on the television are RCA type connectors.
Connect the Y, P
B
and P
R
outputs from the DVD to the AV1 DVD Inputs on the television, as shown below.
Connect the “AUDIO OUT”
to the AV1 IN AUDIO
terminals on the television.
You can also use the AV4
IN for DVD or Set Top Box
connections.
Note:
Some DVD players and set-top boxes only have an RCA “VIDEO OUT” terminal. This can be connected to
any of the VIDEO Inputs on the television. Connect the “AUDIO OUT” to the corresponding AUDIO terminals
on the television.
Y
P
B
P
R
AUDIO OUT
L L
R R
Y
P
B
P
R
DVD OUT
Y-P -P
B R
VIDEO OUT VIDEO
DVD PLAYER
S-VIDEO
VIDEO
L
AUDIO
R
AV5 IN AV 2 IN
COMPONENT
MONITOR OUT
R
P
B
P
Y
MONO MONO
AV4 IN
COM PONENT
R
P
B P
Y
M ONO
AV1 IN
AV4 IN
COMPONENT
R
P
B
P
Y
MONO OR
Connecting S-Video Equipment to the AV Input
S-Video equipment
uses a 4Pin Mini Din
(Male) plug for the
video and RCA plugs
for the audio.
Note:
When an S-Video cable
is connected to an
S-Video input terminal,
the RCA video terminal
for that AV position will
be disconnected.
RF Cable
(Not supplied)
VCR
OUT
AV1 IN
S-VIDEO
VID EO
L
AUDIO
R
AV 5 IN AV2 IN
COMP ONENT
MONITOR OUT
R P
B P
Y
MONO MONO
AV 4 IN
COMPONENT
R P
B P
Y
MONO
AV1 IN
RF CABLE
(Not supplied)
RF OUT