Powermatic 2700 User Manual
Model pm2700 shaper, Operating instructions and parts manual
Advertising
Operating Instructions and Parts Manual
Model PM2700 Shaper
Model: 2700
WALTER MEIER (Manufacturing) Inc.
427 New Sanford Road
LaVergne, TN 37086
Part No. M-1280100C
Ph.: 800-274-6848
Revision F 05/2012
www.powermatic.com
Copyright © 2012 Walter Meier (Manufacturing) Inc.
This .pdf document is bookmarked
Advertising
Table of contents
Document Outline
- PM2700 Shaper
- Warranty and Service
- Table of Contents
- Warnings
- Safety Rules
- Specifications
- Unpacking
- Installing
- Assembly
- Electrical Connections
- Adjustments
- Fence Assembly Movement
- Handwheel Adjustments
- Coplanar Alignment
- Ram Dial Calibration
- Spindle Gib Adjustment
- Featherboard Hold-downs
- Spindle Assembly Installation
- Spindle Assembly Removal
- Shaper Cutter Installation
- Router Collet (Optional) Installation
- Changing Cutter Speed
- Drive Belt Tension
- Belt Replacement
- Precision Miter Gauge
- Operating Controls
- Operations
- Overview
- Safety Devices
- Grain Direction Considerations
- Cutter Rotation
- Using the Fence
- "Z" Dimension
- Depth of Cut
- Straight Edge Shaping
- Edge Shaping
- End Shaping
- Shaping All Sides
- On-Edge Shaping
- Straight Line Bevel Shaping
- Contour Edge Shaping With Collar Bearing
- Shaping With Collars
- Position of Collars
- Starting Pin
- Arcs and Circles
- Enclosed Edge Shaping
- Templates
- Securing the Template
- Special Cuts
- Troubleshooting for PM2700 Shaper
- Optional Accessories
- Parts
- Table – Parts List
- Table – Assembly Drawing
- Fence – Parts List
- Fence – Assembly Drawing
- Frame and Motor – Parts List
- Frame and Motor – Assembly Drawing
- Elevator – Parts List
- Elevator – Assembly Drawing
- Caster Assembly – Parts List
- Caster Assembly Drawing
- Spindle Assembly – Parts List
- Spindle Assembly Drawing-
- Cabinet and Base – Parts List
- Cabinet and Base
- Wiring Diagrams