Panasonic PV C1343 - Manual (Page 8)

8 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected] 8
VHF/UHF
VHF/UHF
VHF/UHF
VHF/UHF
2 / 6 / 2003 THU 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
If AUTO CLOCK SET IS INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK
SET procedure on next page.
AUTO CLOCK SET
IS INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
Initial Setup (Ready to Play)
1
Plug the unit power cord into AC wall
outlet.
• If you use a cable box, turn
it on and set it to the Public
Broadcasting Service (PBS)
channel in your time zone.
If you use a DSS receiver, it
must be turned off
.
Settings are made automatically. When
setup is done, this screen appears.
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening “Nut type” RF coaxial cables
may damage jacks. Finger tighten only.
Please make all cable or antenna connections before power on.
Cable TV
Converter Box
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : STOP
3
Connecting
IN from
ANT./CABLE
Press COMBO on the remote for Combo mode.
Press POWER on the remote or unit.
The unit comes on and auto channel and
clock set starts.
2
UNIT (rear view)
UNIT (rear view)
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
Connections/Initial Setup
(Ready to Play)
• Function buttons are inoperative during Initial
Setup.
• To remove a cassette during Auto Set, press
EJECT twice on the remote or STOP twice on
the unit. In this case, settings must be made
manually. (See page 10.)
• Depending on conditions, Auto Clock Set may
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
VHF/UHF
Notes