Pioneer DV-655A - Manual (Page 48)

The Audio Settings Menu 06
48
En
Channel Level
• Default setting: Fix
This setting allows you to set the level of
each channel sent to the 5.1 channel analog
outputs.
1 Press SETUP and select ‘Audio Set-
tings’ from the on-screen display.
Video Adjust Audio Settings
Play Mode
Setup Navigator
Disc Navigator
Initial Settings
2 Highlight Channel Level, then use the
/ buttons (cursor left/right) to change
to ‘Fix’ or ‘Variable’, as required.
Audio Settings 1/ 1
Audio DRC
Virtual Surround
Channel Level
Off
Off
Fix
• Fix – Channel levels are fixed
• Variable – You can specify variable
channel levels
3 If you chose Variable, press (cursor
down) to proceed to the next screen.
Audio Settings 1/ 2
Audio DRC
Virtual Surround
Channel Level
Off
Off
Variable
4 Variable setting only: Set the channel
levels for each speaker.
Audio Settings 2/ 2
Channel Level L
Channel Level C
Channel Level R
Channel Level RS
Channel Level LS
Channel Level SW
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
• Use the / buttons (cursor up/down)
to select a speaker.
• Use the / buttons (cursor left/right)
to adjust the channel level for that
speaker.
Channel levels can be set from –6 dB to
+6 dB. in 0.5 dB increments.
5 Press ENTER to make the settings and
exit the audio settings screen.
• You can’t adjust the channel level for
any speakers that are set to Off in the
Speaker Installation menu screen
(
page 62).
• The Fix setting is equivalent to setting
all the channel levels to +6 dB. There-
fore, the Variable setting will usually
sound quieter than the Fix setting.