Panasonic KX WP1050 - Manual (Page 133)

Handset Locator and Registration
For assistance, please visit http://www.panasonic.com/help 133
Registering the handset
The handset and the base unit are preregistered. If for some reason the handset is not
registered to the base unit, after you change the base unit’s wireless settings (page 168),
or after you reset all the handset settings (page 123), register the handset. The handset
and the base unit need to be closely located during the registration.
1
{
Menu} (middle soft key)
2
“Settings” i {Select}
3
“Phone settings” i {Select}
4
“Registration” i {Select}
5
“HS registration” i {Select}
6
Press and hold the LOCATOR button on the base unit for 4 seconds until you see the
LOCATOR Indicator on the base unit flashing in green. i {OK}
L
The registration starts. The status message changes from “Handset
registering
” to “Handset registered”.
Note:
L
In step 5, select “Information” to view the network name and BSSID (the MAC
address) information for the base unit. i {Select}
L When the handset registration fails, the status message “Handset could not
register. Please try again.
” is displayed. Press {OK}. Try step 6 again.
L
You can register only 1 handset to the base unit. Therefore, if you register another
handset to the base unit, the previously registered handset cannot be connected to the
base unit.
L
While the handset is being registered, the LOCATOR indicator on the base unit flashes.
LOCATOR button
LOCATOR indicator
WP1050.book Page 133 Wednesday, April 25, 2007 6:01 PM