Panasonic KX WP1050 - Manual (Page 161)

Base Unit Settings
For assistance, please visit http://www.panasonic.com/help 161
3
Configure the settings, then click [Save].
L Check the box in the Log Output column to create a log of each action.
L If you select [Enable] and check “Log Output”, the log will be output. If you select
[Disable], the log will not be output even if you check “Log Output”.
4
Click [Restart].
L The base unit automatically restarts and the Top Menu is displayed.
Note:
L This feature is not available in AP (Bridge) mode.
Setting Description
[Transmission/
reception of
Packets with
private IP
addresses via
WAN interface]
L
Select whether to deny or allow packets to be sent or
received when the source of an incoming (from WAN) packet
and the destination of an outgoing (to WAN) packet are
private IP addresses. This feature is valid when the WAN IP
address is global. The default is set to Deny.
L Check whether output or not this log. The default is set to ON.
[Stateful Packet
Inspection]
L
Select whether to enable or disable the stateful packet
inspection feature.
L
Some E-mail servers authenticate clients using identification
packets which use TCP port 113. If the E-mail feature does
not work well, select [Enable (Except Ident Packets)],
which is the default setting for this feature.
L Check whether output or not this log. The default is set to ON.
[Attack Detection] L Select whether to enable or disable the attack detection
feature. The default is set to Disable.
L
The following type of attacks can be detected:
– TCP Scan
– UDP Scan
– ICMP Echo
L Check whether output or not this log. The default is set to
OFF.
WP1050.book Page 161 Wednesday, April 25, 2007 6:01 PM