Other connections, Other connections 09, Chapter 9 – Pioneer DCS-353 User Manual
Page 31: Connecting external antennas, Connecting auxiliary audio components, Connecting the s-video output
Other connections
09
31
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 9
Other connections
Connecting external antennas
For an external AM antenna, use 5 m to 6 m of
vinyl-insulated wire and set up either indoors or
outdoors. Leave the loop antenna connected.
For an external FM antenna, use a PAL
connector to hook up an external FM antenna.
Connecting auxiliary audio
components
Using the stereo analog inputs, you can
connect an external component such as a tape
deck or MD player for playback through this
system.
•
Connect the AUDIO IN jacks to the analog
outputs of an external playback component.
Connect using RCA pin-plug stereo cables.
•
XV-DV353/360 model
– These jacks are
labeled
LINE
2
on the rear panel.
•
XV-DV151/252 model
– These jacks are
labeled
LINE
on the rear panel.
Connecting the S-video output
Australian model only
If your TV has an S-video input, you can use this
instead of the standard video output for a
better quality picture.
•
Use an S-video cable to connect the
S-
VIDEO OUT
to an S-video input on your TV.
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
Outdoor antenna
5 m to 6 m
Indoor
antenna
(vinyl-coated
wire)
AM LOOP
ANTENNA
PAL connector
LINE 1
VIDEO OUT
VIDEO OUT
AV CONNECTOR
LINE 1
AUDIO IN
LINE 2
R
L
SPEAKERS
R
L
FRONT
CENTER
SURROUND
SUB
WOOFER
R
L
AUDIO
OUTPUT
Tape deck, etc.
XV-DV353/360
R
L
FRONT
SURROUND
S-VIDEO
VIDEO
COMPONENT
VIDEO
C
R
/
P
R
C
B
/
P
B
Y
AUDIO IN
LINE
VIDEO OUT
TV
S-VIDEO
INPUT
XV-DV151/252
XV-DV353_360_151_252.book 31 ページ ２００５年１２月２０日 火曜日 午後４時８分