Pioneer DCS-353 - Manual (Page 42)

Additional information 10
42
En
Tuner
USB connection
HDMI connection (U.K. model only)
Problem Remedy
Considerable noise in
radio broadcasts. • Connect the AM antenna (refer to the Setup Guide) and adjust the direction and
position for best reception. You may also connect an additional internal or external
AM antenna (refer to
Connecting auxiliary audio components on page 31).
• Fully extend the FM wire antenna, position for best reception, and secure to a
wall. You may also connect an outdoor FM antenna (see
Connecting external
antennas on page 31).
• Turn off other equipment that may be causing the noise or move it further away.
•
Australian model only – The tuning interval is incorrect for your country or
region. See Frequency step setting on page 39 to switch the tuning interval.
Auto tuning does not
pick up some stations. • The radio signal is weak. Auto tuning will only detect radio stations with a good
signal. For more sensitive tuning, connect an outdoor antenna.
Problem Remedy
USB mass storage
device is not recognized
by the system. • Make sure you have completely inserted the USB connector to this unit.
• Check that the memory format is FAT16 or FAT32.
• USB devices with an internal USB hub are not supported.
Files don’t show up in
the Navigator/Photo
Browser. • The files must have the correct file extension: .mp3 for MP3 files; .wma for WMA
files; .m4a for MPEG-4 AAC files; .jpg for JPEG files (upper or lower-case is OK).
• Make sure the file permission hasn’t been restricted (through a password, etc.).
Can’t play WMA or
MPEG-4 AAC files. • The files were recorded using DRM (digital rights management) or FairPlay copy-
protection. This is not a malfunction.
Problem Remedy
No HDMI audio output. • See Switching the HDMI audio setting on page 34 to make sure that AUDIO ON
is selected.
No HDMI video output • Make sure that you’ve selected this player as the HDMI input in the settings for
the component you’re using (refer to the component’s instruction manual).
• Check that the HDMI cable is connected properly and isn’t damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible. (components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP).)
• This unit has been designed to be compliant with HDMI Version 1.1. Depending
on the component you have connected, using a DVI connection may result in
unreliable signal transfers.
• Make sure the resolution on this player matches that of the component you have
connected using HDMI (see
Video Output settings on page 26).
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See
Resetting the HDMI connection
on page 34 to reset to the factory defaults.
XV-DV353_360_151_252.book 42 ページ ２００５年１２月２０日 火曜日 午後４時８分