Pinnacle Speakers 3 - Manual (Page 8)

3
•
Simply connect your subwoofer, using either the L or R Line Input jack, to the subwoofer output jack on
your receiver.
•
If you have a Dolby Digital (AC-3) or DTS receiver or processor place the subwoofer's Crossover
Bypass switch in the ON position (this bypasses the Low Pass Filter in the subwoofer).
•
If you do not have a Dolby Digital (AC-3) or DTS receiver or processor place the subwoofer's Crossover
Bypass switch in the OFF position (this activates the Low Pass Filter in the subwoofer).
•
If your receiver or processor has no subwoofer output jack you can connect your subwoofer, using its L
& R input jacks, to your receiver or processor's pre-amp left & right channel outputs. If your receiver or
processor uses jumpers to connect its pre-amp outputs with its inputs you will need to acquire two
splitter cables (Radio Shack #42-2435) to be able to hookup your sub while continuing to provide a signal
to your receiver or processor's inputs.
•
Lastly, wire your left and right front speakers directly to your receiver’s speaker outputs. Please refer to
the Option #1 wiring diagram for further clarification.
OPTION #2 - Using The Binding Post Inputs: