Pioneer AVH-P4100DVD - Manual (Page 86)

Front (front speakers) —Center (center speak-
er)
—Rear (rear speakers)—Subwoofer (sub-
woofer)
—Phase (subwoofer setting)
# You can switch to Phase only when the sub-
woofer has been set to
On.
3 Touch c or d to select the correct size
for the selected speaker.
Each time you touch c or d selects the size in
the following order:
Off (off)
—Small (small)—Large (large)
# You cannot select Off, when Front (front
speakers) have been selected.
# You can select On or Off, when Subwoofer
(subwoofer) has been selected.
# You can switch Reverse (reverse phase) or
Normal (normal phase), when Phase (subwoofer
setting) has been selected.
Correcting the subwoofer
’s phase
If trying to boost the bass output of the sub-
woofer doesn
’t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
’s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch Speaker Setting.
2 Touch a or b to select Subwoofer (sub-
woofer).
Each time you touch a or b selects the speak-
er in the following order:
Front (front speakers)
—Center (center speak-
er)
—Rear (rear speakers)—Subwoofer (sub-
woofer)
—Phase (subwoofer setting)
3 Touch d to turn subwoofer output on.
# To turn subwoofer output off, touch c.
4 Touch b and then touch c or d to se-
lect the phase of subwoofer output.
Touch d to select normal phase and Normal
appears in the display. Touch c to select re-
verse phase and
Reverse appears in the dis-
play.
Note
When playing a 2-channel mono source with
Dolby Pro Logic II turned on, there may be occa-
sions when the following will occur:
! No audio is outputted if the center speaker
setting is Small or Large and no center speak-
er is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
Small or Large.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch Speaker Level.
2 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
Front-L (front speaker left)
—Center (center
speaker)
—Front-R (front speaker right)—
Rear-R (rear speaker right)
—Rear-L (rear
speaker left)
—Subwoofer (subwoofer)
# You cannot select speakers whose size is set
to
Off. (Refer to Setting the speaker setting on the
previous page.)
3 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d it increases or de-
creases the equalizer level.
+10 to
–10 is dis-
played as the level is increased or decreased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
Test Tone. Both provide the same results.
Available accessories
En
86
Section
19