Panasonic KX-FT901BX - Manual (Page 48)

9. Programmable Features
48
9.3 Advanced features
Code #22: Setting the journal report to print
automatically
AUTO JOURNAL
“ ON” (default): The unit will print a journal report
automatically after every 35 new fax
transmissions and receptions (page 27).
“
OFF”: The unit will not print a journal report, but
will keep a record of the last 35 fax transmissions
and receptions.
Code #23: Sending documents overseas
OVERSEAS MODE
If you cannot send a fax overseas even if the
number is correct and the line is connected,
activate this feature before sending the fax.
This feature improves the reliability by reducing
the transmission speed.
“
ON”: After transmission, this feature will turn
OFF automatically.
“
OFF” (default): Deactivates this feature.
Note:
L This feature is not available for broadcast
transmission.
L Calling charges may be higher when using
this feature.
Code #25: Sending a fax at a specific time
DELAYED SEND
This feature allows you to take advantage of low-
cost calling hours offered by your telephone
company. This feature can be set up to 24 hours
in advance of the desired time.
To send a document:
1. Insert the document.
2. If necessary, press {A} or {B} repeatedly to
select the desired resolution (page 27).
3. Press {MENU}.
4. Press {#} then {2}{5}.
5. Press {SET}.
6. Press {A} or {B} repeatedly to select “ ON”.
7. Press {SET}.
8. Enter the fax number.
9. Press {SET}.
10. Enter the transmission start time.
L Press {*} repeatedly to select “ AM” or
“ PM”.
11. Press {SET}.
12. Press {MENU}.
Note:
L To cancel after programming, press {STOP}
then {SET}.
L When transmit polling (page 31) is activated,
this feature is not available.
Code #26: Setting the Caller ID list to print
automatically
AUTO CALL. LIST
“ ON” (default): The unit will print the Caller ID list
automatically after every 20 new calls (page 22).
“
OFF”: The unit will not print the Caller ID list, but
will keep records of the information for the last 20
callers.
Code #30: Changing the silent fax
recognition ring setting
SILENT FAX RING
To change the number of times the unit rings
while in TEL/FAX mode. You can select “
3”
(default), “ 4”, “5”, “6”, “7”, “8” or “9”. See page 36
for details.
Code #31: Setting the ring detection feature
RING DETECTION
See page 38 for details.
Code #36: Reducing the received document
size
AUTO REDUCTION
To slightly reduce the received fax image when
printing, so that the received document will be
approximately the same length as the original
document.
“
ON” (default): The received fax image will be
printed slightly smaller than the original image.
“
OFF”: Deactivates this feature. The received fax
image will be printed at the same size as the
original image.
Note:
L An slight margin will be added to the printed
documents, and therefore if this feature is
turned OFF, the received document will be
slightly longer than the original document.
Code #39: Changing the display contrast
LCD CONTRAST
“ NORMAL” (default): For normal contrast.
“ DARKER”: Used when the display contrast is too
light.
FT-901-903-907BX.book Page 48 Monday, March 29, 2004 10:03 AM